Office and Medical Office Build-Out Electrical in Denver
Tenant improvement power and lighting for offices, clinics, and medical suites in occupied buildings.
Office build-outs live or die on the furniture plan. Modular workstations get fed from floor boxes, poke-throughs, or ceiling whips, and the furniture vendor's harness dictates how many circuits land where, so that plan has to be in hand before the slab gets cored or the deck gets roughed. Lighting is the other half of the package: layout, switching zones, occupancy sensing, daylight-responsive control near glass, and the dimming runs the energy code expects in most commercial space types.
Medical suites add requirements the base building does not have. Exam and procedure rooms classified as patient care spaces carry added rules for receptacle counts, redundant equipment grounding, and listed devices, while imaging equipment, sterilizers, lab gear, and dental chairs each arrive with circuit and grounding requirements from the vendor. Much of this work happens in occupied buildings, which means after-hours panel shutdowns, temporary circuits for the practice next door, and notice to building management before anything goes dark. The work is master-electrician-led, so the person reading the vendor's requirements is the person answering the inspector.
How does power get to open-office furniture systems?
Through floor boxes, poke-through devices, or whips dropped from the ceiling to the furniture feed point. The furniture manufacturer's harness determines how many circuits and neutrals each run carries, so the electrical layout follows the approved furniture plan rather than the architectural plan.
What makes medical office electrical different from a standard office?
Room classification. Spaces where patients are examined or treated fall under health care facility rules that add receptacle counts, redundant equipment grounding paths, and listed devices. On top of that, diagnostic and treatment equipment often needs dedicated circuits, specific receptacle configurations, and grounding to the manufacturer's spec.
Can a tenant improvement be built while the office stays open?
Yes, with phasing. Work gets sequenced so occupied areas keep power and lighting, shutdowns move to evenings or weekends, and temporary circuits cover anything that cannot be interrupted. Building management usually requires written notice before a panel is taken down.
Based in Golden and on site across the Denver metro, from Lakewood, Wheat Ridge, and Arvada to the foothills.